Mitsubishi MOTORS Lancer 2004, Workshop Manual

Page: 252 / 638

DOOR
BODY 42-34
REMOVAL SERVICE POINTS
<<A>> WINDOW REGULATOR
ASSEMBLY/POWER WINDOW
REGULATOR MOTOR ASSEMBLY
REMOVAL
1. Remove the door window glass installation bolts.
CAUTION
If film or others are adhered to the door window
glass, attach special tool window glass holder
(MB990480) to the outside of the glass to prevent
the film from peeling off.
2. Lift the door window glass, and attach special tool
window glass holder (MB990480) to the glass as
shown to prevent the glass from falling.
3. Remove the window regulator assembly and
power window motor assembly
<<B>> CENTRE SASH UPPER REMOVAL
1. Remove the door outer opening weatherstrip from
the centre sash upper only.
2. Remove the centre sash upper mounting screws,
and then remove the centre sash upper from the
door panel.
INSTALLATION SERVICE POINTS
>>A<< CENTRE SASH UPPER
INSTALLATION
Securely insert the centre sash upper into the
window rear sash (door).
>>B<< WINDOW REGULATOR
ASSEMBLY/POWER WINDOW
REGULATOR MOTOR ASSEMBLY
INSTALLATION
When installing the window regulator assembly,
tighten the bolts to the specified torque in the order
shown.
INSPECTION
M1429001400282
How to make the power window switch
learn the fully closed position of the
power window
How to make the power window switch
learn the fully closed position when the
power window switch is removed, or the
power window regulator assembly is
removed or replaced
1. If the anti-trap function (safety mechanism) is
activated consecutively three times or more, the
fully closed position that the power window switch
has learned will be erased (initialised).
2. Operate the power window switch and fully open
the door window glass.
AC100009AB
MB990480
AC000602
Door outer
opening
weatherstrip
Door centre
sash
AB
Y1536AU
Y1476AU
AC100010AB
<FRONT DOOR>
<REAR DOOR>
1
2
3
4
5
6
7
1
2
3
4
5
6