Mitsubishi MOTORS Lancer 2004, Workshop Manual

Page: 350 / 638

FOG LAMP
CHASSIS ELECTRICAL
54A-72
1. Place the screen so that it is directly opposite the
centre of the fog lamp at a distance of 3 metres,
and turn on the fog lamps.
CAUTION
For the front fog lamp which is not being
measured, disconnect that fog lamp’s connector
if possible so that it does not illuminate while
carrying out the adjustment. Furthermore, make
sure that the light axis does not get shifted when
re-connecting the connector.
2. Insert the screwdriver (+) through the aiming hole
on the side under cover. By turning the adjusting
gear for fog lamp aiming, align the cutoff line
(border line of the shadow temperature) with the
specified position in the figure.
NOTE: Horizontal adjustment is not possible.
AC305200AB
In the centre
of front fog lamps
Screen
3 m
H
V
AC305154
Screwdriver (+)
Centre of lamp
Cut-off line
Vertical direction
1.15
˚ (6cm)
High-luminance
zone
H
V
Screwdriver (+)
Centre of lamp
Cut-off line
Vertical direction
1.15
˚ (6cm)
High-luminance
zone
AB