Mitsubishi MOTORS Lancer 2004, Workshop Manual

Page: 57 / 638

TROUBLESHOOTING
ENGINE COOLING
14-11
Q: Are there connectors in good condition?
YES : .
Go to Step 13 .
NO : .
Repair or replace the connector. Then go to
Step 24 .
STEP 13. Check the harness wire between J/C
No.6 C-12 terminal 33 <L.H. drive vehicles> or
C-134 terminal 33 <R.H. drive vehicles> and fan
control relay connector A-09X terminal 1.
Q: Are these harness wires in good condition?
YES :
An intermittent malfunction is suspected
(Refer to GROUP 00 - How to use
troubleshooting
P.00-5 ).
NO :
Repair the damaged harness wire. Then go
to Step 24 .
STEP 14. Check the continuity between fan
control relay connector A-09X and body earth.
(1) Disconnect fan control relay connector A-09X
(remove the fan control relay) and measure relay
box side connector.
(2) Measure the resistance between fan control relay
connector A-09X terminal 3 and body earth.
•
Continuity exists.
(3) Connect fan control relay connector A-09X
(install the fan control relay).
Q: Does the continuity exists?
YES :
An intermittent malfunction is suspected
(Refer to GROUP 00 - How to use
troubleshooting
P.00-5 ).
NO :
Go to Step 15 .
AC303510 AB
Fan control relay
Relay box Connector: A-09X
A-09X
AC303524
Connector: C-12 <L.H. drive vehicles>
AB
C-12
C-12
AC303525
Connector: C-134 <R.H. drive vehicles>
AB
C-134
C-134
AC303510 AB
Fan control relay
Relay box Connector: A-09X
A-09X
AC303510 AB
Fan control relay
Relay box Connector: A-09X
A-09X
AC303533AB
A-09X Connector
(Relay box side)