TM_s-MEXT_ME28relC_00_12_19_EN
Technical manual
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
13
2.3
MAIN MASK
The figure below shows the main mask layout, including the (numbered) areas in which it is divided.
Figure 2-6:
Main mask
The area above displays the hour and the date.
It also displays room humidity and temperature (only when the probe is installed) in real time (also in case the average value mode for the local LAN units connected should
be active). Following is a description of the main mask areas:
Zone 1
: General unit status
Unit off
Unit operating in normal mode
Unit off but with fan in operation at low speed to prevent gas build-up
/
/
Unit operating on steady capacity mode
Normal operation / Maximum flow reached / Minimum flow reached
/
Unit
operating on steady residual ∆P mode
Normal operation / Minimum flow reached
NOTE
If the icon
flashes and the icons
also flash at the same time, this means that the unit is on for post-ventilation of the electric heaters (see the relevant
paragraph in the chapter Heating). The flashing of the
icon together with the flashing of the
icon indicates that the unit is on because it is waiting for the Mr Slim
external unit to switch off.
Zone 2
: Unit detail status
Presence of an active alarm
Unit on stand-by
Maintenance signal
Unit on for exceeding the maximum room temperature
threshold
Active manual controls
Unit on for exceeding the minimum room temperature
threshold
Unit on/off from terminal
Unit on for exceeding the maximum room humidity
threshold
Unit on/off from remote contact
Unit on for exceeding the minimum humidity threshold
Unit on/off from supervision system
Blinking
Unit on for electric heater post-ventilation function
Unit on in local LAN
Unit off and powered by ULTRACAP
Unit turned on for LAN disconnection alarm
ZONE 11
ZONE 1
ZONE 2
ZONE 3
ZONE 4
ZONE 5
ZONE 6
ZONE 7
ZONE 9
ZONE 10
ZONE
12
ZONE 3_A
ZONE 8
D D
Y Y
