APPX
Appendix 5 Processing Time
87
A
Output response delay time
The figure below shows the time from turning on or off of a device of the CPU module to turning on or off of an output of a
slave module.
The output response delay time is the total of
to
in the following figure.
Parameter access response time
The parameters of AnyWireASLINK provide monitoring information of slave modules or the entire system and setting
information of the slave modules.
Parameter data is synchronized between the buffer memory of the FX5-ASL-M and slave modules at a cycle different from
that of the I/O data.
Use the following calculation formulas to obtain the parameter access response time.
(1) Slave module
(2) AnyWireASLINK
(3) CPU module
No.
Description
Required time
Processing time on the programmable
controller
Sequence scan time
Processing time on the FX5-ASL-M
0.6 ms
Transmission time
Transmission cycle time
2
The transmission cycle time differs depending on the number of transmission points. (
Processing time on the slave module
Approx. 0.04 ms (Differs depending on the slave module.)
Output response time on the slave module
Refer to the manual for the slave module connected to the system or the device connected to the
slave module.
Item
Calculation formula
Update interval time of an automatically updated parameter
Number of AnyWireASLINK connection IDs
Transmission cycle time
3
Time required for reading parameters
Number of target IDs
Transmission cycle time
27
Time required for writing parameters
Number of target IDs
Transmission cycle time
39
(2)
(3)
(1)
Summary of Contents for MELSEC iQ-F FX55-ASL-M
