Mitel 600, User Manual

Page: 70 / 97

Mitel 600 Series DECT Phone User Guide
64
Delay Allows you to set the amount of time the DECT phone
can remain outside the vertical position before a
pre-alarm is triggered (1-75 seconds).
Switch Vibra call off in the Ringer settings (see
“Profiles menu” on page 66 ) if you wish to use the
Mandown alarm.
Angle Select the inclination angle of the DECT phone in which
the alarm will be triggered.
Steep : Approximately 45° from the vertical position.
Medium : Approximately 55° from the vertical position.
Flat : Approximately 65° from the vertical position.
The inclination angle will be detected in each axis of the
DECT phone.
No movement alarm
Use Change to switch the no movement alarm on and off.
Alarm in
conversation Switch off this feature to prevent alarm activation by
mistake during an active call.
Delay Allows you to set the amount of time the handset can
remain still before a pre-alarm is triggered (1-75
seconds). To prevent unwanted alarms, pressing any
key on the device resets the delay, e.g. if you are
navigating the menu.
Sensibility Allows you to set the sensitivity (low, medium, high).
This allows you to adapt the sensor to the different
movements (e.g. ways of walking) of the surveillance
personnel:
• Low sensibility means: Slow movements are
enough to reset the delay once again.
• High sensibility means: Only rapid (jolting)
movements will reset the delay.
Switch Vibra call off in the Ringer settings (see “Profiles menu” on page 66 ) if
you wish to use the no movement alarm.
Escape alarm
Use Change to switch the escape alarm on and off.
Alarm in
conversation Switch off this feature to prevent alarm activation by
mistake during an active call.
Delay Allows you to set the amount of time the handset can be
in rapid movement before a pre-alarm is triggered (1-75
seconds).