Mitel 600, User Manual

Page: 39 / 97

Basic functions
33
• SOS call: with confirmation - dial the SOS emergency number only after a safety prompt.
The SOS emergency number is always dialled immediately if the key is pressed and held
down.
You can enter the SOS emergency number in the menu >>> > Security > SOS call > SOS
number . This menu item is not displayed if the SOS emergency number is predefined by the
system.
ALARM SENSOR (MITEL 630D / 632D ONLY)
The Mitel 630d and 632d DECT phones are equipped with an alarm sensor that constantly
monitors the DECT phone’s tilt angle and movement. Various types of alarms can be deduced
from these readings, triggering an automatic alarm call. The only requirement is that you have
programmed an alarm number or SOS emergency number (see
“Emergency call key (SOS)” on
page 32 ) and the Alarm Sensor feature is activated.
The DECT phone supports the following alarms:
• Mandown
• No movement alarm
• Escape alarm
All three alarm types can be activated in parallel. The alarm number is the same for all alarm
types. If no alarm number is stored, the SOS emergency number programmed for the emergency
call key / SOS key is used instead.
The alarm to be signalled is always the first alarm type to be recognized. Activated sensor alarms
are displayed using the
symbol on the first line of the display. To check which alarm is activated,
use the Active features menu (among others).
Make sure the DECT phone is worn on a belt clip, or carry-strap, etc., and not in a pocket, to
ensure that the feature can operate reliably.
Mandown
The DECT phone is normally worn more or less vertically (e.g., attached directly to the wearer’s
belt clip). A position check is carried out continuously to verify that the DECT phone is still in the
vertical position. If the DECT phone is detected as being at a certain (adjustable) angle from the
vertical, an alarm is triggered after a pre-definable amount of time as this may indicate an
emergency.
No movement alarm
This alarm is triggered if the DECT phone has been completely still for a user-definable amount
of time (no movement by the DECT phone or the person carrying the DECT phone). The sensor
has three sensitivity settings. To guarantee a reliable operation it is advisable to test the sensitivity
of the no movement alarm with the person to be monitored. The no movement alarm is switched
off whenever the handset is being charged in the charger cradle or via the USB socket.
Note: On the Mitel 630d and 632d, you can also use the upper SOS key when the key
lock / phone lock is activated.