GUIDE TO INSTALLATION AND OPERATION
10
| RCP-200
13.
Panel Lock/
Standby
Panel Lock –
Press this button to apply a “lock” on the entire panel. Locking the panel takes about 3
to 5 seconds, during which the Panel Lock button flashes red. If another action is detected within this
interval, the operation is cancelled. The button turns steady red when panel is locked. Press and hold
until the button goes to its default color to remove the lock. A lock prevents any action and renders
the entire panel unusable. During a Lock, both displays will show what was previously shown when
the Panel Lock was pressed (no change).
If any activity is detected while the panel is locked, the button flashes to indicate that the panel needs
to be unlocked first.
Standby –
Pressing this key combination (
ALT + Panel Lock
) will put the unit into standby mode. In
Standby mode, the unit turns off the 2 displays and all buttons so that only the Standby button
illuminates blue. Action is instantaneous. When a key is pressed the unit resumes normal operation.
Placing the RCP-200 in Standby mode is recommended before shutting down for maintenance or
disconnecting power, as it ensures that all files are properly saved.
14.
Config/
Panel Config
Press the
Config
button to call up the configuration page on the right-hand LCD screen. From this
page, the interface between the RCP-200 and the network can be configured. See section 4.3 for
details.
•
Panel Config is for future use
15.
Alarms/
Suspend Alarms
(future use)
14
15
13
