GUIDE TO INSTALLATION AND OPERATION
28
| RCP-200
•
Switch between the two views by using the “Switch to …” key on the bottom row, which will always refer to the
alternate mode and appear in the alternate mode’s color.
•
Below the matrix are labels for four soft keys that are assigned to the Router view.
•
On the top right is a table showing Source, Preset and Destination, below which is a numeric keypad to enter
numeric elements of the source or destination identification.
•
The label at the top right (above Src) shows the name of the router that has been selected, as it was displayed in the
Router view configuration screen.
•
The right-most soft key is assigned as the TAKE or SELECT button, depending on the mode in use.
The four soft keys associated with the router view act as selectors to focus on a specific router output. A crosspoint can
only be activated when its associated output is assigned to one of the soft keys, and that soft key is active (button
bright).
To connect a router input (“source”) to a router output (“destination”):
•
The router output must be assigned to a soft key
•
That soft key must be selected (button bright)
•
A source must be selected and loaded into the preset
•
The TAKE button will then be active, and when pushed will connect the preset input to the output associated
with the soft key.
If you want to see what source is currently routed to any destination that is not currently assigned to one of the soft
keys, just follow the instructions below for selecting a destination to select the destination of interest. The current source
will be shown, but not changed.
To operate a router, follow this sequence:
1. Select a destination and assign it to one of the 4 output bus soft keys.
2. Select a source
3. Push TAKE
Selecting a Destination
The destination must be assigned to one of the four soft keys.
If the destination you want is already assigned to one of the soft keys (i.e. it appears in bold on the lower label above
the soft key), then push that soft key (it becomes bright) and proceed to select a source.
If the destination is not assigned to one of the soft keys, assign it as follows:
1. If the destination view (orange matrix background) is not shown, touch the orange
Switch to Dest mode
button
on the bottom row
2. Push the soft key to which you want to assign this destination (it becomes bright)
3. Touch the orange keys and numeric keypad keys to identify the desired destination, per the GUI style you have
chosen.
4. The selected destination will appear in the Dest box on the upper right.
5. Once the destination has been fully defined (no further selection keys enabled), the SELECT soft key will become
bright.
