GUIDE TO INSTALLATION AND OPERATION
RCP-200 |
29
6. Push the SELECT button to assign the selected destination to the soft key.
•
The destination will appear in bold in the lower label above the soft key
•
The upper label line will show the source currently assigned to that destination
Selecting a source
Once you have selected a destination and assigned it to a soft key, proceed as follows to select the source:
1. If the source view (green matrix background) is not shown, touch the green
Switch to Src mode
button on the
bottom row
2. Touch the green keys and numeric keypad keys to identify the desired source, per the GUI style you have
chosen.
3. The selected source will appear in the Pst box on the upper right.
4. Once the source has been fully defined (no further selection keys enabled), the TAKE soft key will become bright.
Activating the crosspoint
Push the TAKE button to activate the crosspoint and assign the selected source to the selected output
•
The labels above the selected soft key (bright) will show the source and destination you have chosen, as will the
Src and Dest windows in the upper right corner of the display.
5.3.4 Using the Category Index GUI:
The Category Index GUI may be used to perform four tasks:
•
Select a device to control in iControl services
•
Select a source while controlling a router
•
Select a destination while controlling a router
•
Activate a router crosspoint
The following description applies to all of these in general. Where specific differences arise for one of these tasks, it will
be pointed out in the text.
Here is a sample screen in Device Selection mode:
Tip:
When using the Category Index GUI type, it is possible to directly enter the actual input number
(source mode) or output number (destination mode) of a router to select a source or destination.
