Minolta MAGICOLOR 2, Manual

Page: 131 / 188

OPC Belt
Cartridge
Problems
8-21 Troubleshooting Printer Problems
4 Is the printer printing codes or not printing at all when in
ESP mode?
n
Reconfigure the port to the specific printer emulation of
the file you are trying to print. See chapter 4, “Printer
Configuration,” in the
Reference manual for instructions.
n
If a PostScript file prints PostScript statements while the
printer is in ESP mode, increase the ESP timeout. See
chapter 4, “Printer Configuration,” in the
Reference man-
ual for instructions.
n
If you continue to have problems with the ESP mode
selecting the appropriate printer emulation, contact your
QMS vendor.
OPC Belt Cartridge Problems
The OPC belt is extremely sensitive to bright light and direct sunlight.
Always leave it in its protective bag until you are ready to install it. Any
exposure to light should be limited to two minutes. If you suspect the
belt is damaged due to exposure to light, put the belt in a dark place
to recover. Depending on the amount of exposure, recovery may take
up to two hours. Recovery time is dependent on the amount of expo-
sure sustained, and recovery is not guaranteed.