Minolta MAGICOLOR 2, Manual

Page: 144 / 188

Image Defects
QMS magicolor 2 Op eration 8-34
Toner Smudges
Printout Too Light
Toner smudges only on the front of the page:
1 Check to make sure the toner cartridges are not
pushed in too far.
Don’t push a toner cartridge in until you hear a click.
If you hear a click, you’ve locked the cartridge into
place against the OPC belt cartridge, and your prints
may be smudged. Pull the toner cartridge out so that
it’s firmly seated but not locked into place.
2 Distribute the toner.
3 Check to make sure the toner cartridge is not defective.
4 If steps 1, 2, and 3 do not solve the problem, install a new toner cartridge.
Toner smudges on the front and back of the page:
1 The image transfer roller may be dirty. Open the printer once and close it
again to clean the roller.
1 Remove the toner cartridges and rock them as you
would when installing a new cartridge. This redistrib-
utes toner inside the cartridges. Then, reinstall the
cartridges.
2 The toner cartridges may be defective. Install new
toner cartridges.