Minolta Di251, Service Manual

Page: 148 / 362

I-60 Di251/Di351 Rev. 1.1.0.0/03.01
left
3. Verify that the following parts and accessories are included in the contents of
the box.
1. Transport unit black guide-rail molding..................1
2. Pipe........................................................................1
3. Finisher set pin ......................................................1
4. Magnetic fitting.......................................................1
5. Thumbscrews ........................................................3
6. Label 1 (main unit) .................................................1
Label 2 (ADF) ........................................................1
7. Transport unit.........................................................1
8. Feeder attachment.................................................1
9. Mail-bin ..................................................................5
NOTE
The copier must be configured with at least 5 tiers of paper feed units plus Copy
Table, or with 3 tiers and a large capacity unit (or Copy Desk) in order to install the
Finisher.
Make sure that the unit is set up on a level surface.
After the setting-up procedures have been completed, do not move the entire
system unless absolutely necessary. If for some reason it should become
necessary to move the system, first remove the horizontal transport unit and then
remove the pipe from both the Finisher and the copier. In this case, first remove the
pipe from the Finisher, then remove it from the copier.
After the system has been relocated, perform the following steps again: “Installing
the transport unit” and “Attaching the pipe” shown on p. 3.
1
2
3 4
5
6
7
8
9