24
C
al
ib
ra
tio
n
Please select the method of SPAN calibration referring to [4-3. Selection of Calibration Method]
Please select the method of SPAN calibration referring to [4-3. Selection of Calibration Method]
１
2
3
SPAN is memorized, and displays
Please push key with displayed.
* Please put the weight equal to the mass set to the
measuring part by step 6 [Set the mass of weight]
記憶している
ロードセル出力値
設定した
ロードセル出力値
Memorized load cell
output value
Set-up load
cell output value
mV/V
mV/V
SPAN calibration by the weight
Step
8
(Actual weight calibration)
SPAN calibration by numeric input
Step
8
(Electric calibration)
to end of calibration
▲
to end of calibration
▲
Push key after blinks and turns on.
STABLE
2
3
１
After the setting, by pushing key, displays.
* Memorized load cell output value is displays.
By pushing key, displays, and then by
mV/V
mV/V
Please set the value in which the output value equal to ZERO
is subtracted from the load cell output value equal to the set
weighing capacity in each mV/V.
Select the digit to be selected.
Change the value of digit to be changed.
Pushing key, of condition is turned on, and
displays
F
ENTER
CAL-Z
CAL-Z
CAL-Z
CAL-Z
CAL-S
CAL-S
ENTER
ENTER
FF
ENTER
ENTER
FF
ENTER
ENTER
FF
SPAN is registered by reading the output value in the condition to
put the weight set according to step 6.
SPAN is registered by inputting the value in which the load cell output
value of ZERO is subtracted from the output value of the load cell
expected when the load for
measuring is put.
Error display of SPAN calibration
blinks for about 2 seconds when the output and input value of lo ad cell doesn't reach
within the range of the span adjustment range ([Load cell output voltage at SPAN] -
[Load cell output voltage at ZERO]
≦
0.0 mV/V)
blinks for about 2 seconds when the span width of inputting numeric amount
for output and input of the load cell (the width from ZERO to SPAN) exceeds
over the span adjustment range (higher than 3.1 mV/V).
* Please con
fi
rm the rated capacity of load cell and mass of the weight so that SPAN should not
exceed the adjustable range.