Mindray DPM 1, Operator'S Manual

Page: 15 / 54

2-3
No. Description Remarks
1 ID number It displays current ID number ranging from 000 to 100
2 ID Full It appears when ID
≥
95 and blinks when stored ID is
being covered by new ID.
3 Memory Full It appears when previous data is to be covered by new
data. Please refer to 5.1.1 Data Storage.
4 Pulse Strength It can display 7 segments at most to indicate real time
pulse strength.
5 SpO2 value It displays SpO2 value and is refreshed every second.
6 PR value It displays PR value and is refreshed every second.
Unit: bpm (beats/minute)
7 Low battery It appears only when the battery energy is low.
2.6 Button Operation
Three soft buttons are available on DPM1’s front panel.
Power Backlight Confirm ID
Figure 2-4 Buttons
2.6.1 Power Button
„
Power-on: Press to turn on the device.
„
Power-off: Press and hold for two seconds to turn off the device.
NOTE
z
DPM1 is powered by batteries only. Please install batteries before use as described
in 3.2 Install Batteries.
z
In case the SpO
2
cable becomes disconnected or the finger moves away from the
sensor, DPM1 will automatically enter the standby mode. Under this mode, when a
finger is inserted into the sensor, DPM1 will automatically resume the operation
mode. Otherwise, if no finger is inserted in 5 minutes, DPM1 will automatically
shut down.