MIMAKI DM3-1810S, Operation Manual

Page: 53 / 146

- 2.19 -
Plotting an image from source data
4. During the plotting.
5. After the plotting operation is completed, put
the machine back into the LOCAL mode.
The table will move toward you when plotting in the Cycle
Start mode.
• The origin and the print area remain un-
changed after plotting. You must reset them
if they need to be changed. ( page 2.9)
Interrupting the plotting operation
To interrupt the plotting operation, stop the carriage and erase (the receive data) from the machine.
STEPS:
1. Press the [REMOTE] key to stop the plotting
operation.
2. If data is being transmitted from the computer
to the machine, stop the data transmission.
3. Press the [DATA CLEAR] key.
The data that has been received is erased.
4. Press the [DATA CLEAR] key or [ENTER] key.
The machine enters the LOCAL mode.
• The green pilot lamp indicates that there is no data in the machine.
<< LOCAL >>
X =1010 Y = 1860
<< LOCAL >>
X =1010 Y = 1860
DATA CLEAR
< ENT >
<< LOCAL >>
X =1010 Y = 1860