MIMAKI DM3-1810S, Operation Manual

Page: 107 / 146

- 6.5 -
Correct the head height.
( page 2.6)
Close the station cover or release
the stop switch.
Replace a filter.
( page 3.10)
Press the XY key or select [Sta-
tion]-[Carriage Out] to cap the
head. ( page 5.8)
Contact your local MIMAKI
distributor or call a local MIMAKI
office for services. The parts
may be used until new parts are
delivered.
REPLACE BATTERY
Wiper
Replace Wiper
Wiper
Clean Wiper Shaft
Head Height
Check Head Height
Check Stop SW or
Station Cover
Blower Filter
Replace Filter
Please Capping
The Head
Service Call
001
Service Call
002
Warning message Cause Corrective measure
Problems where error messages are given on the LCD
The station cover is open or the
stop switch is pressed.
It indicates when the filter at the
right/left absorption table must
be replaced.
Head stays uncapped for more
than 30 seconds.
Time to replace regularly
replaceable parts.
Replace the battery.
Plotting will be enabled by press-
ing the [REMOTE]. Then, the
error message will not appear until
the power is returned on. It is
recommended, however, to replace
the wiper with a new one as soon
as possible.
The battery is weaken.
Time to replace the wiper in the
capping station with a new one
has come and clean the bottom
of the slider.
The wiper guide shaft is dirty.
The waste ink tank cannot be
found.
Waste ink tank is full.
Waste ink tank will soon full.
Waste Ink Tank
No Ink Tank
Waste Ink Tank
Ink Tank Is Full
Waste Ink Tank
Ink Tank Near Full
Set the waste ink tank correctly.
Remove the waste ink tank and set
an empty waste ink tank.
Clean the wiper guide shaft.
The head height is incorrect.