MIMAKI CG-100AR, Operation Manual

Page: 92 / 184

Chapter 3 Cutting Data with Register Marks
92
2
Press the [ENTER/HOLD] key.
• Only the sheet width is detected, after which register mark detection starts.
• If [ROLL. SELECT] is set to [ON], select the number of pinch rollers to be used. "Setting the
Number of Pinch Rollers to Use"(P. 56)
• [ERROR C36 MARKdetect] appears on the display if no register marks can be detected.
If this occurs, reload the sheet.
3
Once the register marks have been detected, set using the scale compensation setting screen.
• The following example shows the procedure for four-point detection.
• Set using if the detected register mark distances differ from the measured values.
• Press the [ENTER/HOLD] key to proceed to the next scale compensation setting.
• If [DIST.REVI.] is set to [OFF], the screen for setting scale compensation does not appear.
• If [MARK DETECT] is set to [2ptA], the screen for entering distance B does not appear.
• If [MARK DETECT] is set to [2ptB], the screen for entering distance A does not appear.
• If [MARK DETECT] is set to [1pt], the scale compensation screen does not appear. Proceed to
Step 4, and set the origin.
4
Press the [ENTER/HOLD] key after setting.
• Set the origin.
• The available cutting area is displayed before switching to local mode.
Detecting Register Marks Using Semi-Automatic Detection
If TP1 cannot be placed at the full-automatic register mark detection position or if register marks cannot be
detected using full-automatic detection, detect register marks manually.
Pinch roller