MIMAKI CG-100AR, Operation Manual

Page: 109 / 184

Chapter 4 Helpful Tips
109
4.5 Selecting the Cutting Movement
Direction [ROTATION]
Set the origin position and direction of the coordinate axes to match the application software being used.
(Rotation function)
Rotation not set
Rotation set
Origin
Origin
The carriage stops at the origin position after sheet detection.
• The settings are retained even when the power is turned off.
• Check to confirm that no data to be cut has been saved in the receive buffer.
Altering the setting clears the receive buffer contents.
• Rotation cannot be enabled if the register mark detection function is enabled.
• First turn off the register mark function before enabling rotation.
"Detect register
marks."(P. 89)
• Altering the rotation setting initializes the cut area settings.
Setting Rotation
1
Press the [FUNCTION] key in local mode.
2
Use to select [SET UP], then press the [ENTER/HOLD] key.
3
Use to select [ROTATION], then press the [ENTER/HOLD] key.
4
Use to select [ON] or [OFF], then press the [ENTER/HOLD] key.
• ON: The coordinate axes are rotated and the origin is moved at the same time.
• OFF: No rotation is performed.
5
Press the [END] key several times to exit.
4