Chapter 2 Cutting
74
Pausing Cutting
1
Press the [REMOTE] key while cutting is in progress.
• Cutting is paused.
• If data is being sent from a PC, data transmission is paused at the PC.
2
Press the [REMOTE] key.
• Cutting resumes.
• An error message will appear if operation functions or operations affecting the command
coordinate system are performed while cutting is paused.
If an error message appears, either quit cutting or use data clear to abort cutting.
Aborting Cutting (Data Clear)
• If data is not cleared, data already received will be cut on returning to remote mode.
• If data is cleared and data is received after returning to remote mode, new data will be cut.
• Do not clear data while data is in the process of being sent.
1
Check to confirm that data is not currently being received.
• Check, at the top right of the screen, that the amount of data received is not increasing.
• Do not clear data while data is being received.
2
Press the [REMOTE] key.
• Cutting is paused.
3
Press the [FUNCTION] key.
4
Press
to select [DATA CLEAR], then press the [ENTER/HOLD] key.
• The data is cleared.
• The data received remains within the receiving buffer even after using data clear. Repeated
cutting is possible using the multiple sheet cutting function.
Retracting the Carriage
The carriage remains over the platen after cutting has ended. To check the cutting results or to load a new
sheet, push the clamp lever to the rear, then move the carriage away from the platen by hand.
Summary of Contents for CG-100AR
