MIMAKI CG-100AR, Operation Manual

Page: 137 / 184

Chapter 5 Settings
137
Item
Setting
*1
Details
[SHEET TYPE] "SHEET TYPE"(P. 140)
• STANDARD: When using regular sheets
• HEAVY: When using heavier sheets
(The maximum cutting speed setting will be
limited to 20 cm/s, and the tool will be moved at
20 cm/s even if the up speed is set to a value
over 20 cm/s.)
SORTING ON/OFF Sets whether to alter the cutting sequence before
cutting.
"Changing the Cutting Sequence
[SORTING]"(P. 116)
ADJ-PRS OFFSET
[ADJ-PRS OFS] -9 to 0 to 9 When cutting the corners, the pressure is
automatically decreased (by about 5 g) to prevent the
sheet from lifting up. As a result, the cutting blade
might not rotate smoothly and may leave uncut parts.
Adjust the pressure for cutting the corners if they are
left uncut.
(Approx. -30 g to 30 g)
"ADJ-PRS OFFSET"(P. 140)
PINCH ROLL - "Setting the Number of Pinch Rollers to
Use"(P. 56)
OVER CUT OFF/0.1 to 1.0 mm Overlapping the start and end points prevents the
sheet from being left uncut.
"Preventing Uncut Media [OVER CUT/CORNER
CUT]"(P. 121)
CORNER CUT ON/OFF The machine performs over cutting at corners other
than the start and end point.
"Preventing Uncut Media [OVER CUT/CORNER
CUT]"(P. 121)
Start mode
[START MODE] LOCAL/REMOTE Sets the mode after sheet detection.
• LOCAL:
The machine waits in local mode after sheet
detection.
• REMOTE:
The machine automatically switches to remote
mode after sheet detection.
Pressure correction
[PRESS COMP.] ON/OFF Corrects any variations in cutting pressure depending
on location to unify the cutting performance.
Register mark search
[SEARCH MARK] ON/OFF Set the automatic register mark search function after
sheet detection.
"Detecting Register Marks Automatically After
Sheet Detection"(P. 95)
Pen setting
[PEN SETTING] - -
Down Speed 0 to 20 to 64 Sets the pen down speed. Increasing the setting
increases the speed.
When cutting heavy sheets 1 mm or more thick, the
pen nib may be dragged if the down speed is too fast.
In such cases, the down speed should be set to a
value not greater than 20.
CURVE MODE FAST/SLOW Sets the cutting speed for curved lines.
5