Milwaukee M18 SMS216, Original Instructions Manual

Page: 32 / 153

29 29
BATTERY PACK PROTECTION
In extremely high torque, binding, stalling and short circuit
situations that cause high current draw, the tool will stop for about 2
seconds and then the tool will turn OFF. To reset, remove the battery
pack from the tool and replace it.
Under extreme circumstances, the internal temperature of the
battery pack could raise too much. If this happens, the fuel gauge
will flash until the battery pack cooled down. After the lights go off,
the work may continue.
Place the battery on the charger to charge and reset it.
MAINTENANCE
Remove the battery pack before starting any work on the appliance.
Be sure to disconnect the tool from the power supply before
attaching or removing the saw blade.
Replace the table insert when worn
Clean tool and guarding system with dry cloth.
The ventilation slots of the machine must be kept clear at all times.
Use only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described,
please contact one of our Milwaukee service agents (see our list of
guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state
the Article No. as well as the machine type printed on the label
and order the drawing at your local service agents or directly at:
Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
SYMBOLS
CAUTION! WARNING! DANGER!
Remove the battery pack before starting any work on the
appliance.
Please read the instructions carefully before starting the
machine.
Always wear goggles when using the machine.
Wear ear protectors!
Wear gloves!
Always keep hands away from the path of the saw blade.
Never expose tool to rain.
Do not stare into beam.
EDITION : A
xxxxxxxxx xxxxxxxxx
29x11.6(4-R0.5)mm
(
±
0.2mm)
g
50# UL silver foil
Matt PP coating
Permanent Acrylic Removeable Acrylic
Other
CM001xxxxx
ECN-CM01xxxx
River Liu
2018.June.22
01
Black + Pantone Yellow C
Total: 2C
Laser warning label_for SMS216 & M18 MS216 EMEA version
Description:
MODEL NO
WEIGHT
VENDOR
PART NO
ITEM ID
REV.
SIZE
SCALE : 100%
Approved By:
Graphic Designer
Approved By:
Electrical Engineer
Approved By:
Quality Assurance
Approved By:
Chief Designer / Eng, Manager
MATERIAL
ECN#
CORE:
LAMINATION:
ADHESIVE:
COLOR
LASER
1M
29mm
11.6mm
Pantone
Yellow C
Do not view directly into beam with optical
instruments (binocular, telescope).
This product corresponds to the laser class 1
in accordance with EN 60825-1:2014 .
Do not dispose electric tools, batteries/rechargeable batte-
ries together with household waste material. Electric tools
and batteries that have reached the end of their life must
be collected separately and returned to an environmentally
compatible recycling facility. Check with your local authori-
ty or retailer for recycling advice and collection point.
V
Voltage
Direct Current
n
0
No-load speed
Saw blade dia. x hole dia
European Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
English
GB