7
Grass Bag
When using the grass bag, remove the mulch plug.
Inspect grass bag frequently and replace with rec-
ommended replacement if there are signs of wear
or deterioration.
1. Remove battery packs.
2. Lift rear door.
3.
Place the grass bag onto the mower so the bag's
metal hooks rest on the metal bar of the mower
housing.
4.
Lower the grass bag so bag covers the rear dis-
charge opening.
5.
Lower the rear door; the rear door will rest on the
grass bag.
6.
To remove, lift rear door and pull grass bag up and
away from the mower.
Rear Side Discharge Chute
When using the discharge chute, remove the mulch
plug. Inspect discharge chute frequently and replace
with recommended replacement if there are signs of
wear or deterioration.
1. Remove battery packs.
2. Lift rear door.
3.
Align the center notch of the discharge chute to
the one on the mower housing.
4.
Slide the discharge chute into the body of the mow-
er until the white embossed arrows of the discharge
chute are aligned with those on the mower housing.
5.
Gently push down on the discharge chute to en-
sure it is fully seated.
6.
Lower the rear door; the rear door will rest on the
discharge chute.
7.
To remove, lift rear door and pull discharge chute
away from the mower.
Removing/Inserting the Batteries
To
remove
the batteries, push in the release buttons
and pull the battery packs away from the mower.
WARNING
Always remove the battery packs
any time the mower is not in use.
To
insert
the batteries, slide the packs into the
body of the mower. Make sure they latch securely
into place.
NOTE:
The mower requires two charged battery
packs to operate.
•
The mower will not work with only one battery pack.
• If one battery pack is completely discharged, the
mower will not function, even if the second battery
pack is charged.
• For best results, use with (2) MILWAUKEE HIGH
OUTPUT
™
HD12.0 battery packs.
Fuel Gauge
Use the Fuel Gauge to determine the lowest battery
pack's remaining run time. When less than 10% of
charge is left, 1 light on the fuel gauge will flash 4
times. When the battery reaches 0% charge, 1 light
on the fuel gauge will flash 8 times. Charge the bat
-
tery packs.
If the Fuel Gauge doesn't appear to be working,
place the battery pack on the charger and charge
as needed.
Immediately after using the battery pack, the Fuel
Gauge may display a lower charge than it will if
checked a few minutes later. The battery cells "re
-
cover" some of their charge after resting.
Fuel Gauge
Lights
Diagnosis
Solution
Lights 1 - 4
Solid
Remaining
run time
Continue working
1 Light,
flashing slowly
Less than
10% run time
left
Prepare to charge
pack
1 Light,
flashing quickly
End of
discharge
Charge pack
