MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
102
6.10 Remote selection of programs via MIDI (RMT)
&
This function is intended for switching sub-programs and so should be undertaken within a
“global program“. For more information refer to section 6.10.5 on page 104 “Combining
control methods“. Don’t use this function in the program that you are currently working on
except in special cases or it could lead some off-putting results!
This function allows the selection of Matrix Programs, or the loading, selection and starting
of Songs using MIDI Program Change commands. As soon as the device receives the relevant
command at the chosen MIDI input, it will select the required Matrix Program or Song. If the Song is
not in memory, a disk scan is undertaken and the Song loaded.
&
This function can be used on the inputs only. Even though songs can be called up using
MIDI Remote, it is still classed as a Matrix function.
$
Call up the MIDI Remote function:
»
"
« and select
»
RMT
«
.
In the top right of the display you will see the number and name of the current MIDI input or
output. LEDs light on the number keys representing inputs or outputs which already have
settings.
$
Press
or
,
and select an input or output using
to
.
If the Remote Processor has been programmed for an output, it reacts on Program Changes
issued through Routing from the inputs or by playing back a Song. Program Changes that are issued
by the Matrix functions “Program Change“ or “Send Data“ will be ignored.
&
By programming the Remote Processor to be active on one of the outputs you can switch
your Matrix Programs by Program Change events in the Song. You need only to assign the
corresponding Song track to this output using the Output Assign function.
If you work with General MIDI (or GS- or XG-, or GM2-) modules simoultaniously as a
playback module and expander for your playing, think that a Standard Midi File send a
reset at the beginning of the Song. With steering this function via the Song you have to
activate the corresponding Matrix program after the General MIDI reset of the Song.
6.10.1 Direct control of particular Banks
6.10.1 Direct control of particular Banks
6.10.1 Direct control of particular Banks
6.10.1 Direct control of particular Banks
➊
Set the MIDI channel on which remote control is to happen and press
.
➋
Set the Bank on which Program Changes are to have direct effects and press
.
Reception of a Program Change on that MIDI channel causes not only the Program within
this Bank to be changed, but also the Bank to be simultaneously activated.
Remote: 1:
1
2 3 4 5 6 7 8
Remote: Ch 1 bank: 1 1:
TMR
➭
off Read
