Midea Aqua Tempto Power Series, Manual

Page: 199 / 213

MCAC-ATSM-2014-09 Aqua tempo power series tropical air-cooled scroll chiller 50Hz
197
T
≤
Ts- δ
2
T
<
Ts+1-
δ
Ts-1+ δ >
T ≥ Ts+1-
δ
Ts-1+ δ ≤T ＜Tj2
T ≥Tj2
(TAL: total outlet water temperature)
Operation method: Turned off, press the "Constrain" "
▲
" 2 button for
3 seconds to enter the hysteresis setting selection. Can be adjusted
Hysteresis parameter
δ
= (2,3,4,5
°
C). Press
“ ”
or
“
▲
”
key
to select the desired value, 7S key operation Or press the Enter key,
then exit and save the settings and return to the main page. During
setup, press the "Cancel" key, does not save the parameters and
exit.
The factory default δ = 2°C .
2) ADDRESS setting function
The address of wire controller can be set by pressing this button. The address range 0~15, therefore, 16 wire
controller could be parallel at most. Operation meth
od: Press “Constraint” "
▲
" two button for 3 seconds to
enter the wired remote address selection. Press “ ” or “
▲
” key to select the desired value. 7S key operation
or press “OK” key to exit and save the settings and return Page. Not saved during set up, press the Cancel
key parameters and exit.
3) The fault is cleared
This feature can clear the fault and protection has been ruled out. Methods
of operation: press the "Constraint" " " two button for 3 seconds to clear
the fault. Page of the main page and Inspection press this key combination,
you can clear the entire system fault, the fault code cleared at the same
time.
1.1.4. Check
1) Check function allows the user to query all the operating parameters and error and protection information
of the main unit.
2)
Enter method: long press “Set” key for 3 seconds to enter check interface, as the figure display: