Midea Aqua Tempto Power Series, Manual

Page: 117 / 213

MCAC-ATSM-2014-09 Aqua tempo power series tropical air-cooled scroll chiller 50Hz
115
c
、
Delete wired controller: Select an existing wired controller (as above method), and click
“
Delete
”
, if there
is no outdoor module controlled by any wired controller (see Fig. 4-22), the one could be deleted; if there are
outdoor modules controlled by wired controller (see Fig. 4-23), a failed delete message box would pop up
(see Fig. 4-24). As long as delete all modules under connect the wired controller, the wired controller could be
deleted.
Note: Please select wired controller according to actual system condition.
②
Click the
“Module parameter setting”, a window as Fig.4-25 will pop up: add module group under connect
with the wired controller
a
、
Add sub-module: Select the existing wired controller address from the
“
KJR Address
”
, and select the
configured module group at the drop-down box of
“
Module name
”
, select the sub-module address in the
drop-down box of the configured
“
Sub-module address
”
, a
nd then click “Add”. The sub-module would not be
configured, if the sub-module address without configured in this wired controller; if sub-module is exists, a
message box would pop up as Fig. 4-26 to note you, the sub-module cannot be configured. If the sub-module
quantity exceeds than the maximum module under connect with wired controller, the message box as Fig.
4-27 will pop up.
b
、
Delete sub-module: Select the sub-module which wanted to delete (select the wanted delete sub-module at
the drop-down box of
“
Sub-module address
”
), and click
“
Delete
”
to finish this operation.
3
） “
Schedule management
”
includes:
“
Weekly timing setting
”
and
“
Error record
” 。
See Fig. 4-28
Fig.4-21
Fig.4-22
Fig.4-23
Fig.4-24
Fig.4-25
Fig.4-26 Fig.4-27