Midea Aqua Tempto Power Series, Manual

Page: 195 / 213

MCAC-ATSM-2014-09 Aqua tempo power series tropical air-cooled scroll chiller 50Hz
193
Turn on the unit
Press the key again until all
modes are showed (i.e. Cooling,
Heating and Pump modes.)
Press “mode settings” key to set the
intended mode.
Power up to module unit and initially deliver
power to wire control.
Press “OK” key to save the settings.
Unit will run after press “ON/OFF”
key 3 minutes later.
Tu r n o f f t h e u n i t
W h e n i n t e n d t o s h u t t h e u n i t
P r e s s “ O N / O F F ” k e y
To s e l e c t t u r n - o
ff s e t t i n g s
Setting operating modes and parameters
Press “Setting” key to enter the operation mode and parameters setting. The setting contents will change
as the following order each time the key is pressed:
→ →
→
WATER
TEMP.
TIMER TEMP. DIFFERENCE MODE
1) Setting water temperature: under main page directly press the
“▲”
or
“▼”
to adjust the water
temperature, or press
“
Setting
”
key to enter and then press
“▲”
or
“▼”
to adjust. At that time the
LCD will display
“
Setting temperature
”
and
“
Water temperature
parameter
”
, as the following display. Query water temperature setting:
press the
“ ”
or
“
▲
”
key under the main page to query the set
water temperature numerical value.
2) Timing setting: can set 3 timing periods on the wire controller: Timer
1, Timer 2, Timer 3, and then control the main unit to ON and OFF in
different periods. Setting method: press “Setting” key under main page
twice to enter timing setting. At that time the LCD will display as the following:
1
TIMER
ON