Microtronix Access User Guide
The route setup page provides a route table with all the X.25 to TCP/IP route entries along with a form
for route editing.
6.2.1 Route Table
Upon loading the
X.25 to TCP Routes
page, the
X.25 to TCP Routes
table presents the currently
defined X.25 to TCP/IP routes. The higher the route is ranked in the table, the higher the scanning
priority. As entries are added, modified and ranks adjusted, the table will change. These changes are
not finalized until the
Save and Apply Changes
button has been clicked.
6.2.2 Creating a New Route
1.Under the Identify inbound X.25 connection section of the route edit form, enter the following:
Select the
X.25 Device
which is connected to the peer X.25 host
The
Connection Type
, which is either Switched Virtual Circuit (SVC) or Permanent Virtual
Circuit (PVC).
If an SVC type has been selected, a
Called X.25 Address
may be entered. If a PVC type has
been selected, a
Logical Channel Number
in the defined range must be entered.
A
Calling X.25 Address
may be specified. This will be inserted into the source or calling
address field of the X.25 call request.
1.Under the Generate outbound TCP/IP connection section of the route edit form, enter the
following:
The
Conversion Type
for the TCP/IP connection.
The
IP Address
of the remote TCP/IP host.
The TCP port number that the remote TCP/IP host is listening on.
1.Click the
Add Entry
button to add the route to the route table. The new route will be added as the
lowest rank.
2.Use the up and down arrows to adjust the ranking of the new route. The lower the number, the
higher the priority the route will take in the scan for a match.
NOTE:
routes added to the table do not take effect until the
Save and Apply Changes
button has been
clicked.
6.2.3 Editing an Existing Route
1.In the
X.25 to TCP Routes
table, a route may be selected for editing by clicking the radio button
located within the
Edit
column of the table in the corresponding route row. Once selected, the route
will be loaded into the Route Editing form.
2.Within the form, the route may be modified.
3.In order for the route to be updated in the route table, the
Update Entry
button must be pressed.
The
Add Entry
button may also be pressed if a new route is to be created using an existing route
as a template.
47
