Microtronix Access User Guide
3.4 Configuring the X.25/TCP Gateway
To set up a port for X.25 use, click on the
L1-Device
,
L2-LAPB
, and
L3-X.25
items in the
X.25 WAN
section of the main menu to display the configuration form for each layer of the protocol. Configure the
parameters to match the attached device. Refer to the
X.25 WAN
section for configuration details:
L3-
X.25
,
L2-LAPB
, and
L1–Device
.
Click on the
Status
item of the
X.25 WAN
section to display the operational status of the X.25
interfaces, and
LCI Status
to display the operational status of any active logical channels. Refer to the
X.25 Status
section for details on the display of X.25 interfaces, and
LCI Status
for details on the
display of logical channels.
To configure the X.25 to TCP mapping / routing, click on the
X.25 to TCP Routes
item in the
X.25
Gateway
section of the main menu to display the configuration form. Add or modify routing entries to
map incoming X.25 connections to outbound TCP connections.
To configure the TCP to X.25 mapping / routing, click on the
TCP to X.25 Routes
item in the
X.25
Gateway
section of the main menu to display the configuration form. Add or edit routing entries to map
incoming TCP connections to outbound X.25 connections.
Click on the
Connection Status
item of the
X.25 Gateway
section to display the operational status of
any active X.25–TCP connections.
Refer to the
X.25 Gateway
sections for configuration details:
TCP to X.25 Routes
, and
X.25 to TCP
Routes
, the
Connection Status
item for details on the status display of X.25-TCP connections, and the
Control and Log
item for detail on that display.
3.5 Configuring a Terminal Server
To set up a port for asynchronous / serial use, click on the
Serial - TCP
item in the
Terminal Server
section of the main menu to display the configuration form. Configure the interface parameters to
match the attached device, and assign the TCP/IP network parameters to be connected to this
interface. Click on the
Status
item in the same section of the main menu to check the interface
operation.
Refer to the
Terminal Server
sections:
Serial - TCP
item for configuration details, the
Status
item for
details on the status display, and the
Control and Log
item for details of that display.
3.6 Configuring a Synchronous Server
To set up a port for synchronous / HDLC use, click on the
Synchronous - TCP
item in the
Sync Server
section of the main menu to display the configuration form. Configure the interface parameters to
match the attached device, and assign the TCP/IP network parameters to be connected to this
interface. Click on the
Status
item in the same section of the main menu to check the interface
operation.
Refer to the
Sync Server
sections:
Synchronous - TCP
item for configuration details, the
Status
item
for details on the status display, and the
Control and Log
item for details of that display.
19
