Microtronix Access User Guide
6.1.5 Show Facilities
Selecting
Show Facilities
provides additional parameters in the edit form display. This allows for
further generation of additional X.25 call facility parameters including packet and window negotiation.
6.1.6 TCP to X.25 Route Parameters
6.1.6.1 Identify inbound TCP/IP connection
Remote IP Address:
IP address of the remote IP host. Used to further qualify an incoming TCP/IP
connection request.
Remote TCP Port:
TCP port number of the remote IP host. Used to further qualify an incoming TCP/IP
connection request.
Local IP Address:
The IP address of the local interface to which the listening TCP port will be bound.
This field will be used as a matching criteria when finding a destination. If not specified, connections to
any local IP address will be accepted.
Listening TCP Port:
TCP port number on which the gateway is listening. The remote IP host uses this
as the destination port number.
Conversion Type:
Conversion type that will be used for TCP/IP data transfer, XOT, MBIT, RAW, RAW-
MBIT, RFC1006, Q-MBIT, RBP, QRBP, AEPN, OFTP, LINE, or IAC-ESC. The remote TCP/IP host
application must support this method. Refer to the
Conversions And Encapsulations
section for details
6.1.6.2 Generate outbound X.25 connection
Called Address:
X.121 address inserted into the called (destination) address field of the outbound call
request. Not used for PVC.
Device:
Physical device port to which the peer X.25 device is connected, hdlc0 (WAN port 0), hdlc1
(Console/WAN port 1), ANY (either WAN port), or XOT (X.25 Over TCP with X.25 termination).
If the peer X.25 device is attached to a remote XOT router, then select “XOT”, and specify the IP
address and TCP port number of the remote XOT peer device.
XOT IP Address:
IP Address of the remote XOT peer. Relevant only when Device (above) is set to
“XOT”.
43
