Chapter
3
Optics and Lighting
3-8
Vision HAWK Smart Camera Guide
Wiring for Strobe Illumination (NPN)
In
Strobe
mode, the external illuminator is strobed with the exposure of the camera to
maximize light for the short exposure times needed in dynamic applications.
Warning:
Contact between Pin 5 (gray wire) and any ground or voltage source less than
or equal to 3.5VDC may cause erratic operation in this configuration. Contact between Pin
5 (gray wire) and any voltage source greater than 3.5VDC will damage the illuminator.
Smart Series Illuminator
Vision HAWK (Connector A)
Pin
Signal Name
Pin
Signal Name
1
+24VDC
to
2
Power
2
Trigger –
to
6
Output 3
3
DC Ground
to
7 and 12
Ground and Output Common
4
T
to
2
Power
5
Dim
to No Connection*
N/A
* Insulate Pin 5 (gray wire)
Smart Series Illuminator
Connector
Vision HAWK
Connector A
Summary of Contents for Vision Hawk Smart Camera
