Setting Up a Job in AutoVISION
System Component
s
2
Vision HAWK Smart Camera Guide
2-25
Once you have selected your camera, adjusted its settings, and
created a new job, you will move to the
Image
view. This view allows
you to
Auto Calibrate
the camera, and to manually adjust the
camera's Exposure, Gain, and Focus, and also to set the Lighting
Mode (On, Off, or Strobe).
3.
Edit the Job in AutoVISION.
After you have created a new job, loaded a job from your PC, or
uploaded a job from the camera, you will proceed to the
Edit
view to
refine your machine vision job. The Camera parameters below the
captured image allow you to set Gain, Exposure, Focus, Trigger, and
Lighting. Inspection Outputs options allow you to connect your job to
the outside world. This is also the view where you can add multiple
tools to the job. The tool icons are located above the main view area.
Summary of Contents for Vision Hawk Smart Camera
