Microscan MS-890, User Manual, Page: 64 / 308

3-20
MS-890 Industrial Automation Scanner User Manual
Daisy Chain Scanner ID
Daisy Chain Scanner ID
Note : Scanner IDs can also be assigned in Daisy Chain (Aux Port Mode) (page 3-14).
Scanner Number
Scanner ID
Note: See also Chapter 13, Output Format .
Note : After a secondary scanner accepts a new ID, it automatically invokes a
reset-with-save command.
Usage:
This command provides a convenient way to assign custom daisy chain IDs
to specific scanners that were assigned during the daisy chain autoconfigure
process.
Definition:
Assigns a new daisy chain ID to a daisy chain secondary scanner. The command
is sent to the master scanner to configure the other secondary scanners.
Definition:
Specifies the target scanner (by sequential number) which will be receiving
the new daisy chain ID. The master scanner is always 0 (zero). All secondary
scanners are numbered 1...n in the order that they are connected.
Note : These numbers are for assigning IDs only and are not
changeable.
Serial Cmd:
< K151, daisy chain scanner #
,daisy chain scanner ID
>
Options:
1....n (0 for the master scanner)
Definition:
A two-character user-defined ASCII message identifying a scanner in the
daisy chain.
Serial Cmd:
< K151,
daisy chain scanner #,
scanner ID >
Default:
Sequential numbering of scanner units resulting from the Daisy Chain
Autoconfigure <K150 DAISY > command; for example: ID Master = 1/ ;
ID Scanner 1 = 2/ ; ID Scanner 2 = 3/ ; etc.
Options:
Any two characters except NUL , < , > , or ,
.