DMC 2000S Dosimeter
15-00007 Page 46 of 65
The following message is displayed:
The modifiable parameters can now be accessed by simply pressing and releasing the
selector button.
The parameters are then displayed in the order as outlined in the section
, page 40.
8.4.2.
Procedures for modifying parameters
Parameter modification is performed in the
modification
mode. The preceding section
describes how to access this mode.
The procedure is the same for all modifiable parameters
There are three steps in setting parameters:
8.4.2.1.Step “ P ”
The flashing “P” displayed to the left of the “functional indicators” identifies this step. It
allows all modifiable
parameters
to be
accessed.
!
pressing and releasing enters the current parameter and takes you to the next one
!
pressing and holding the selector button takes you to the next step
8.4.2.2. Step “d”
This step is identified by the flashing
“d”
displayed to the left of the “functional
indicators”. It allows you to access each
digit
of the current parameter.
!
pressing and releasing allows you to access the next digit
!
pressing and holding the selector button takes you to the next step
Note
: this step is not included for the “general” parameters such as “RESET” or
“TOTAL”.
