DMC 2000S Dosimeter
15-00007 Page 29 of 65
6.2.6.4. Rate pre-alarm warning threshold display
This value corresponds to the pre-alarm threshold of the dose rate for the main
measurement (shown here:
0.130 mRem/h
).
6.3 Switching to pause mode
Switching to the
pause
mode implies deactivating the
DMC 2000S
dosimeter. In other
words, suppressing the dose equivalent measurement.
To switch to the
pause
mode when using the DMC 2000S in the autonomous mode, press
the selector button and follow the procedure listed below:
!
The selector button should be held pressed in for approximately 10 seconds. The
following messages are displayed in succession:
!
When this “go out” message is displayed,
immediately
release the selector button.
The following messaged is displayed briefly:
The dosimeter is now in the
pause
mode. The display indicates the following:
!
the functional indicators are flashing
!
one of the following messages can be displayed (depending on the dosimeter
configuration: assigned or non-assigned, etc.):
