DMC 2000S Dosimeter
15-00007 Page 24 of 65
6. Operation in the autonomous mode
6.1 Switching to the measurement mode
Switching to the
measurement
mode implies activating the
DMC 2000S
dosimeter. In other
words, programming the dose equivalent measurement.
It is performed from the
pause
mode, as explained below.
!
the display as it appears in the
pause
mode is shown below:
The flashing colon on the display indicates the dosimeter is functioning.
!
the following message is displayed when the selector button is pressed:
!
after approximately 3 seconds, the following message is displayed:
!
while this message is displayed, press and immediately release the selector button
!
NOTE: the above message is displayed for less than two seconds
!
if successful, the following message appears briefly on the display:
!
Along with this message, the dosimeter audibly “beeps,” the red LED flashes” and a display test
is performed, which activates all segments of the LCD display.
