DMC 2000S Dosimeter
15-00007 Page 41 of 65
8. Setting operating parameters
8.1 In the satellite mode
When the DMC 2000S is in the Satellite mode, all operating parameters can be modified.
Modifying parameters in this mode requires the use of an LDM 2000 or LDM 101 reader
connected to MGPAC, the centralized dosimeter software, or DOSIMASS, the dosimeter
maintenance software.
8.2 In the autonomous mode
When the DMC 2000S is in the Autonomous mode, the user can directly modify the main
operating parameters by simply using the selector button. No other equipment is required.
This can only be accomplished while the dosimeter is in the
pause
mode.
8.3 Modifiable parameters
The parameters which can be modified are described below in the order in which they
appear on the display when the selector button is pressed. However, depending on the
dosimeter configuration, some parameters may not be displayed.
8.3.1.1. Cumulative dose
modifiable in both the satellite (with an LDM-101 or LDM 2000 and the appropriate
software) and autonomous modes
Or
This parameter configures the absorbed dose to be cumulative or reset to zero during each
usage period.
!
The message
“ total ”
indicates that the dosimeter is accumulating the dose equivalent
values after each use of the dosimeter.
!
The message
“ reset ”
indicates that the dosimeter resets to zero each time it is
switched into the
measurement
mode.