Tube Ref
No.
Description
Where Used
Part No.
Extreme Grease
Length of driveshaft
8M0071842
•
Lubricate the splines on the propeller shaft.
•
Drain and replace the gearcase lubricant.
•
Inspect all belts, pulleys, and idler pulleys for deterioration.
•
Check the fuel pressure.
1.
•
Check the control cable adjustments.
•
Inspect the battery.
•
Check the corrosion control anodes.
•
Check the tightness of all fasteners.
•
Check the power trim fluid.
•
Use Quicksilver products to remove engine deposits. See your dealer for
an explanation of which products to use.
EVERY 100 HOURS OR ONCE A YEAR, WHICHEVER OCCURS FIRST
•
Tighten the fasteners that secure the outboard to the boat transom to the
specified torque.
1.
Description
Nm
lb‑in.
lb‑ft
Outboard mounting locknuts and
bolts – standard boat transom
75
–
55
Outboard mounting locknuts and
bolts – metal lift plates and setback
brackets
122
–
90
•
Replace the water pump impeller (more often if overheating occurs or
reduced water pressure is noted).
1.
•
Replace the spark plugs after the first 100 hours or first year. After that,
inspect the spark plugs every 100 hours or once yearly. Replace the
spark plugs as needed.
•
Replace the water‑separating fuel filter.
•
Replace the in‑line oil filter after the first 100 hours of operation.
•
Use Quickleen in the fuel.
•
Verify that the cowl seals are intact and not damaged.
•
Check that the internal cowl sound reduction foam (if equipped) is intact
and not deteriorating.
•
Ensure that the intake silencer (if equipped) is in place.
•
Ensure that the idle relief muffler (if equipped) is in place.
•
Check for loose hose clamps and rubber boots (if equipped) on the air
intake assembly.
MAINTENANCE
76
eng