Mercedes-Benz B 250 e 2015, Owner'S Manual

Page: 278 / 293

must be positioned vertically, directly under
the jacking point of the vehicle.
!
Position a suitable jack correctly on the
intended jacking points. If you fail to position
the jack correctly, the vehicle may be dam-
aged.
The jacking points for the jack are recesses in
the lower door sill. They can only be seen from
underneath. There is one located behind each
of the front wheel arches and in front of the
rear wheel arches.
Position the jack in the jacking points so that
when viewed from the side, the jack is in the
vertical position.
!
Position a suitable jack only on the jacking
points intended for this purpose.
Never position the jack on the high-voltage
battery. Do not jack up the vehicle on the
high-voltage battery. There is otherwise a risk
of damaging the high-voltage battery.
Also observe the notes in the "Changing a
wheel" section.
Observe the following when raising the vehi-
cle:
R
to raise the vehicle, only use the vehicle-spe-
cific jack that has been tested and approved
by Mercedes-Benz. If the jack is used incor-
rectly, it could tip over while the vehicle is
raised.
R
the jack is designed only to raise and hold the
vehicle for a short time while a wheel is being
changed. It is not permissible to use it to per-
form maintenance work under the vehicle.
R
avoid changing the wheel on uphill and down-
hill slopes.
R
before raising the vehicle, safeguard it from
rolling away by applying the parking brake and
positioning wheel chocks. Do not release the
parking brake while the vehicle is raised.
R
the jack must be placed on a firm, flat and
non-slip surface. On a loose surface, a large,
flat load-bearing underlay must be used. On a
slippery surface, a non-slip underlay must be
used, e.g. rubber mats.
R
do not use wooden blocks or similar objects
as a jack underlay. Otherwise, the jack will not
be able to achieve its load-bearing capacity
due to the restricted height.
R
make sure that the distance between the
underside of the tyres and the ground does
not exceed 3 cm.
R
never place your hands or feet under the
raised vehicle.
R
do not lie under the vehicle.
R
do not start the drive system when the vehicle
is raised.
R
do not open or close a door or the tailgate
while the vehicle is raised.
R
make sure that no persons are present in the
vehicle when the vehicle is raised.
X
Using wheel wrench : , loosen the bolts on
the wheel you wish to change by about one
full turn. Do not unscrew the bolts completely.
Jacking points
The jacking points are located just behind the
front wheel arches and just in front of the rear
wheel arches (arrows).
Changing a wheel
275
Wheels
and
tyres
Z