A
p
Switches the right-hand front reading
lamp on/off
B
Switches the automatic interior lighting con-
trol on
Control panel in the grab handle in the
rear compartment
:
Switches the reading lamp on/off
Interior lighting control
General notes
In order to prevent the vehicle's battery from
discharging, the interior lighting functions are
automatically deactivated after some time
except when the key is in position 2 in the igni-
tion lock.
The colour and brightness for the ambient light-
ing may be set using COMAND Online or Audio
20 (see the separate operating instructions).
Automatic interior lighting control
X
To switch on: set the switch to centre posi-
tion
B
.
X
To switch off: set the switch to the
|
position.
The interior lighting automatically switches on if
you:
R
unlock the vehicle
R
open a door
R
remove the key from the ignition lock
The interior lighting is activated for a short time
when the key is removed from the ignition lock.
This delayed switch-off can be adjusted using
COMAND Online or Audio 20 (see the separate
operating instructions).
Manual interior lighting control
X
To switch the front interior lighting on: set
the switch to the
c
position.
X
To switch off the interior lighting: set the
switch to the
|
position or (if the door is
closed) to the centre position.
X
To switch the rear interior lighting on or
off: press the
u
button.
X
To switch the reading lamp on or off: press
the
p
button.
Crash-responsive emergency lighting
The interior lighting is activated automatically if
the vehicle is involved in an accident.
X
To switch off the crash-responsive emer-
gency lighting: press the hazard warning
lamp button.
or
X
Lock and then unlock the vehicle using the
key.
Replacing bulbs
Important safety notes
Xenon bulbs
G
DANGER
Xenon bulbs are under high voltage. You can
get an electric shock if you remove the cover
of the xenon bulb and touch the electrical
contacts. There is a risk of fatal injury.
Never touch the parts or the electrical con-
tacts of the xenon bulb. Always have work on
the xenon bulbs carried out at a qualified spe-
cialist workshop.
If your vehicle is equipped with xenon bulbs, you
can recognise this by the following: the cone of
light from the xenon bulbs moves from the top to
the bottom and back again when you start the
drive system. For this to be observed, the lights
must be switched on before the drive system is
started.
Bulbs and lamps are an important aspect of
vehicle safety. You must therefore make sure
that these function correctly at all times. Have
the headlamp setting checked regularly.
Replacing bulbs
103
Lights
and
windsc
ree
n
wi
pers
Z
Summary of Contents for B 250 e 2015
