Technical Manual Presence Detector SCN-P/G360XX.02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 •
Fax: +49-2263-4588
• [email protected] • www.mdt.de
22
22
4.2.6 External Push Button Input
The following figure shows the settings for the external push-button input:
Figure 12: Settings - External push button input
The following table shows the possible settings for these parameters:
ETS-Text
Dynamic range
[Default value]
Comment
External push button
short/long reacts to
only ON
only OFF
ON and OFF
Selection of which telegrams are valid
for the external pushbutton
Use 2x external
button short
stay in automatic mode
switch to manual mode
Setting what should happen if the
"External push button - short" object
receives an OFF command twice in
quick succession.
Table 11: Settings - External push button input
With the external push-button input, the presence detector can be switched on independently of
movement detection..
The object for the "external push-button short" switches the presence detector to the next state (see
also 4.2.8 Process diagram).
In contrast, the object "External push button long" always switches the motion detector directly On
or Off.
The following table shows the general communication objects:
Number
Name
Length
Usage
3
Light channel 1
–
Input
–
External push button short
1 Bit
Object for the output of an external push-button;
is used for manual switching between the states
of the light channel or for switching on the light
channel in the half-automatic mode.
4
Light channel 1
–
Input
–
External push button long
1 Bit
Object for the output of an external push-button;
is used for manual switching ON/OFF of the light
channel
Table 12: Communication objects - External push button input
4.2.7 Idle time after switch-off
The idle time after switching off defines the time that the presence detector is blocked for further
detection after the follow-up time has elapsed.
