Technical Manual Shutter Actuator JAL-0X10X.02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49
-2263-4588
• [email protected] • www.mdt.de
43
43
4.7 Behaviour after bus power down/bus power up
Attention:
The parameter "Behavior after bus power down" is only be available for devices with auxiliary
voltage (4-fold and 8-fold)!
The parameters for the behavior after bus power down/bus power up can be seen below:
Figure 11: Behaviour after bus power down/bus power up
The following table shows the possible settings for these parameters:
ETS-Text
Dynamic range
[default value]
Comment
Behavior after bus power down
no action
move up
move down
stop moving
„
move to p
ositio
no action:
No specific action is
performed after a bus power down.
move up:
Channel moves up.
move down:
Channel moves down.
stop moving:
An active movement
is stopped.
„ ove to positio
:
Only displayed
when the "1Bit Object for move to
position" has been activated. The
position defined there is
approached.
Behavior after bus power up
no action
move up
move down
„
move to p
ositio
Table 16: Setting options - Behaviour after bus power down/bus power up
Attention:
If a blocking or an alarm occurs in the event of a bus power down/ bus power up, the
blocking/alarm has the higher priority than the behavior for bus power down/ bus power up.
