MaxPac Dual/Triple-Screen 8230 XRA2/3-Series User Operation and Maintenance Guide
3
Unpacking the System
MaxPac 8230 XRA2/3-Series systems are always shipped in an associated Pelican case. Depending
on the configuration of your system – two or three screens and up to four disk drives – the
Pelican/MaxPac combination may weigh between 84 lbs and 99 lbs (including the packaging). If you
are unable to lift this weight safely, you should obtain assistance in unpacking and moving the system.
1) Place the cardboard packing box containing the Pelican case and MaxPac system on the floor.
Remove the packing slip from the outside of the box and save it for later use as discussed below.
2) Clear an area on a desk or table on which to place the MaxPac system.
Note:
In order to raise or lower the handle on the Pelican case, use your thumb to slide the release
catch to the right (if looking toward the back of the case as shown in Figure 1-1).
Figure 1-1. Use the release catch to operate the handle on the Pelican case
3) Place the Pelican case flat on its back on the floor and open it (Figure 1-2).
Figure 1-2
Figure 1-3
Figure 1-2. Open the Pelican case containing the MaxPac System
4) With the aid of a colleague, carefully tip the case such that its lid is on the floor as shown in
Figure 1-3 (note that the case was rotated 180
o
from the view shown in Figure 1-2 prior to it being
tipped for the purposes of these photographs).
Summary of Contents for 8230 XRA2 series
Page 6: ......
