60
MaxPac Dual/Triple-Screen 8230 XRA2/3-Series User Operation and Maintenance Guide
Note:
These disks are hot-swappable, so you can replace individual drives while the magazine remains
resident in the system. When the upper binding bar is removed, the four slots in the main drive cage
may slide back. Make sure that when replacing the upper binding bar that the tabs go into these slots.
Note:
In order to easily identify these disks, MaxVision serial numbers are affixed to the bottom edge
(the small white strips shown toward the bottom of the drives in Figure 3-57). It is recommended that
you record the positions and serial numbers of your disks for each MaxPac (especially when you are
actually replacing individual disks).
Optical Drive (CD/DVD)
1) Note that it is not necessary to open the display assembly into its service position in order to
perform this procedure.
2) Undo the two knurled attaching the CD/DVD drive to the outside of the system's main chassis
(Figure 3-61).
Figure 3-61
Figure 3-62
3) Gently remove the CD/DVD drive from the system (Figure 3-62).
4) Take the new CD/DVD assembly as supplied by MaxVision support and incorporate it into the
system by performing the steps described above in reverse order.
Optical Drive (CD/DVD) Backplane
1) Open the display assembly into its service position as discussed earlier in this chapter.
2) Remove the CD/DVD drive as discussed in the previous topic.
3) Remove the ATA cable (observing where the red stripe is for future reference) as illustrated in
Figure 3-63.
Summary of Contents for 8230 XRA2 series
Page 6: ......
