56
MaxPac Dual/Triple-Screen 8230 XRA2/3-Series User Operation and Maintenance Guide
Figure 3-45
Figure 3-46
3) Use a Phillips #2 screwdriver to remove the two 6-32 screws attaching the card’s retaining
bracket – and the special linking bracket – to the inner chassis (Figure 3-45 and 3-46).
Figure 3-47
Figure 3-48
4) Gently remove the special linking bracket and store it somewhere safe.
5) Some PCI Express cards may have an auxiliary power connector. If so, disconnect it as shown
in Figure 3-47.
6) Take the new PCI Express card and incorporate it into the system by performing the steps
described above in reverse order.
Note:
Ensure that the tongue on the new/replacement card’s faceplate lines up with the slot in the
chassis (you may have to bend the tongue slightly in the case of a new card).
Note:
When removing the video cables, keep track of the order of the connections to the PCI
Express card. The right-hand display is connected to the top connector and the center display is
connected to the bottom connector of the primary PCI Express card. In the case of a triple-display
system, the left display connector (which is a different shape to the other two) is attached to the
bottom DVII connector of the secondary PCI Express graphics board.
Note:
In this system there is no plastic latch holding the rear of the PCI Express card. The foam
attached to the hinged inner lid of the MaxPac will hold pressure to the back of the card when
properly secured
Summary of Contents for 8230 XRA2 series
Page 6: ......
