Page 75 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Assembly
1.Remove Shroud from packaging;
note Shroud is turned inside-out to
mount to Helmet.
3. Turn FCC front TurnClip horizontal and
attach Shroud front Mounting Hole over
TurnClip. Turn TurnClip vertically to
secure the attachment.
5. Snap one side of DLC onto one
side FFC Attachment Post; then
snap other side.
7. Pull Shroud over and
down the back of the
Helmet.
8. Use Pull Tap to position Shroud Rear Snap
over FCC Rear Snap; snap and secure.
Disassembly
Reverse Asssembly steps to remove Shroud from Helmet.
WARNING
Dispose of contaminated Shrouds according to institutional protocol for contaminated waist.
CAUTION
Read Sections 1 through 13 before proceeding.
2. Grasp top of DLC Cuff and
pull gently away from Lens
so that Cuff and Flappers
are away from Lens.
6. Hold helmet securely, grasp Shroud’s
rear Pull Tab and pull shroud up and
over helmet.
9. Snap and secure left Rear Side
Snaps between Shroud and FCC.
Then repeat on right Rear Side
Snaps.
4. Pull Shroud top fabric up over the
front TurnClip and tuck it in under
and/or close to the FCC bottom
edge all around FCC.
WARNING
Start with the ML size for medium to large head sizes; the SM is for very small head sizes.
