Page 101 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Don Battery, Belt, Helmet and Hood
1. Remove all System Components from their packaging, ensure they are ready for use, and lay them on a clean counter with labels facing you.
4. Attach (snap) one side Hood-
Lens mounting hole to respec-
tive Helmet side mounting post.
Repeat on other side.
3. Attach (snap) center
Hood-Lens mounting
hole over Helmet cen-
ter mounting post.
5. Grasp the back of the
Hood Filter and begin
to pull the Hood up and
over the Helmet.
2. Assemble the Battery onto a double layer of Belt. Place top edge
of Belt under the Battery Clip, up to the Clip top, so the Clip Detent
rests on the Clip Base and NOT the Belt. Place the belt comfortably
around the waist with the battery near the side-back of the right hip.
6. Continue pulling the Hood
over the Helmet down to
within about 1-2 inches from
the top rear Helmet Snap.
7. If the Hood Filter if folded over the front
Velcro Strip, “flip” the fold up to expose
the Velcro Strip. Pull the Hood down fur-
ther in back to remove the wrinkles from
the Hood Filter over the Helmet top.
8. Connect Helmet Power Cord
to Battery. Push Power
Cord Connector into Battery
Receptacle until Secure
Connection audibly clicks.
12. Pull Hood Shrouds over top of
Helmet and down in back.
9. Loosen the ratchet
adjustment knob
counter-clockwise to
ensure the Helmet will
easily fit over the head.
10. Pull the Helmet
over and down on
to your head.
11. Tighten Ratchet Knob (clockwise)
as tight as possible without causing
discomfort to secure Helmet on head
for all anticipated activities.
13. Pull Hood Shrouds
down all around.
14. Grasp Hood front just below Lens and
Hood back just below Filter. Pull down
firmly to smooth out any wrinkles of the
Filter.