Page 51 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
10.
Standard System Assembly, Donning, and Doffing
CAUTION
If there is any question about the disinfection status of the CAPR System due to a previous use, it is recommended to
disinfect it before using.
1. Obtain a fully charged battery.
(Charger LED should be green after
battery is connected to charger for
more than 10 seconds.)
3. Place the belt comfortably
around the waist with the
battery near the side-back of
the right hip.
2. Assemble the battery onto the belt.
Place the top edge of the Belt under the
Battery Clip. Move the Belt fully under
and up to the top of the Clip.
1. Connect Helmet
Power Cord to
Battery. Push
Power Cord
Connector into
Battery Receptacle
until Secure
Connection audibly
clicks.
Assemble and Don the Battery and Belt
This section describes assembly, donning, and doffing the Standard DLC Cuff System. The majority of procedures in are
applicable to all other face/head covers, particularly with regards to battery, charger, helmet adjustments, and facial fit.
Differences for other configurations are covered in the respective sections for those other face and head covers.
1. Obtain the
appropriate
DLC from the
DLC dispensing
box.
2. Align FCC front TurnClip
horizontally, snap the
DLC Front Alignment
Hole over the TurnClip.
Position the TurnClip
vertically to lock DLC in
place.
3. Align and snap one DLC
Side Attachment Hole over
the respective FCC Side
Attachment Post.
Repeat for other side.
4. Pull the DLC
Peel Tab up,
over and to the
left to remove
the Lens
Protective Cover
off the Lens.
4. Slide your fingers between the
Cuff and face from each temple
down and under your chin to
pull the DLC Flappers away
from the Lens, and to properly
position the Cuff.
2. Loosen the ratchet
adjustment knob
counter-clockwise to
ensure the Helmet will
easily fit over the head.
3. Hold the Helmet in one hand, pull
the front top edge of the DLC Cuff
down, and place your chin into the
DLC Cuff. Then, pull the Helmet
over and down on to your head.
NOTE
Generally, start
with the ML
(Medium/Large)
size face/head
cover, unless
the user has a
particularly small
size head.
Assemble the DLC (Disposable Lens-Cuff)
Don the Helmet DLC System