Page 109 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Assembly - Liner (when necessary) and Hard Hat to Helmet
1. Place the Liner front
under the Helmet front to
align Helmet Snaps with
Liner Snap Holes.
The 2083-03 ships with a 2051-07 assembled as a shipping protector, a 2071-03 Hard Hat Liner, and a 2590-05 Power Cord.
2. Press the Liner
front right and left
snap holes over the
Helmet front right
and left snaps until
secure.
3. Align the Helmet
Power Cord with the
Liner Cord cutout and
press the Liner rear
against the Helmet.
4. Press the Liner rear
right and left snap
holes over the Helmet
rear right and left
snaps until secure.
5. Ensure the Liner
outer edges curls up
and over the Helmet
edge, all around the
Helmet.
6. Locate the inside hole in the
Hard Hat front Turn Clip, and
the Helmet front Snap.
7. Place the Helmet front snap
securely in the Hard Hat
front Turn Clip inside hole.
8. Pull the Hard Had down over
the back of the Helmet until its
T-Tab hole is over the top rear
Snap on the Helmet back.
9. Continue downward
movement of Hard Hat
until its T-Tab hole snaps
securely on Helmet snap.
Disassembly - Liner and Hard Hat from Helmet
Disassembly of the of the Liner and Hard Hat is the reverse of Assembly steps 1-9, immediately preceding.
CAUTION
A Filter Cartridge must to be installed on the Helmet before use;
1. Refer to Section 10, page 45, for instructions to remove the 2051-07 SnapOn Cage.
2. Assemble Filter Cartridge to Helmet: Hold Helmet in one hand, lower Filter Cartridge by plastic retainer ring
down onto helmet (A), snap rear Cartridge Tab to Rear Helmet Snap (B); snap each side Cartridge Tab to each
side Helmet Snap (C). If necessary, press Retainer Ring down close to front Helmet Adapter (D) to get side Tabs
over side Snaps (E).
3. Assemble Hard Hat to Helmet: Locate Helmet front Mounting Adapter (E), locate Hard Hat front Mounting Hole (F); Place Adapter into
Mounting Hole (G); pull Hard Hat over and down on Helmet (H) until Hard Hat T-Tab (I) is over and snaps to lower rear Helmet Snap (J).
D
C
B
A
J
I
H
G
F
E
Assembly - Filter Cartridge to 2083-03 Helmet; Hard Hat to 2083-03 Helmet
F
E
C
