Page 83 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Prepare Hood and Helmet for Assembly
1.
Remove hood from packaging and lay it
on counter with lens/snaps facing up.
2.
If necessary use a thin, flat blade to gently remove
Front, Rear, and Side Adapters from their respective snaps.
Assembly
3. Snap one side of Hood DLC to one side
snap of Helmet (DLC Cuff facing in).
4. Snap front of Hood DLC to center
Helmet snap.
5. Snap other side of Hood DLC to
other side snap of Helmet.
6. Grasp Hood Snap Tab and begin pulling
hood up and over helmet.
7. Continue pulling over and down
the back of the helmet.
8. Secure the Hood Snap Tab on the
lower rear Helmet snap.
Disassembly
WARNING
Dispose of contaminated Hoods according to your Institution’s
protocols.
Reverse steps 3 through 8 to remove Hood
from Helmet.
NOTE
Read Sections 1 through 13 before proceeding. If one is attached, remove the Filter Cover Cap
(Section 13).
Assemble the 2165-10 Filter Cartridge per Section 12.
